Page 1 of 1

More great prints !

Posted: October 19th, 2017, 8:09 am
by LePaul
I've been printing the BB-8 circular panels. Minimal support, just on the edges to aide in adhesion and then under the center and where there are openings/holes.

Simplify3D time projections are way off, but this took 49 hours.

0.2mm layer height from bottom to mid ring, then 0.1mm for the rest. 20% infill
Capture.PNG

Re: More great prints !

Posted: October 19th, 2017, 8:11 am
by LePaul
Again, really impressed that this stock CR-10, with no really big tweaks (strain relief and bigger bed leveling knobs...) is doing so well.

I really wish Ultimaker offered a large scale machine. But at $380 and these sorts of results...I could buy 10 CR-10's for the cost of their best printer!