I've been printing the BB-8 circular panels. Minimal support, just on the edges to aide in adhesion and then under the center and where there are openings/holes.
Simplify3D time projections are way off, but this took 49 hours.
0.2mm layer height from bottom to mid ring, then 0.1mm for the rest. 20% infill
More great prints !
- LePaul
- Reactions:
- Posts: 3970
- Joined: February 7th, 2016, 10:26 pm
- Location: Bangor, Maine USA
- 3D Printer(s): 24 - Yes I have a problem!
- Contact:
Re: More great prints !
Again, really impressed that this stock CR-10, with no really big tweaks (strain relief and bigger bed leveling knobs...) is doing so well.
I really wish Ultimaker offered a large scale machine. But at $380 and these sorts of results...I could buy 10 CR-10's for the cost of their best printer!
I really wish Ultimaker offered a large scale machine. But at $380 and these sorts of results...I could buy 10 CR-10's for the cost of their best printer!