More great prints !

Creality brand 3D Printers!
Post Reply
User avatar
LePaul
Reactions:
Posts: 3963
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): 24 - Yes I have a problem!
Contact:

More great prints !

Post by LePaul »

I've been printing the BB-8 circular panels. Minimal support, just on the edges to aide in adhesion and then under the center and where there are openings/holes.

Simplify3D time projections are way off, but this took 49 hours.

0.2mm layer height from bottom to mid ring, then 0.1mm for the rest. 20% infill
Capture.PNG
User avatar
LePaul
Reactions:
Posts: 3963
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): 24 - Yes I have a problem!
Contact:

Re: More great prints !

Post by LePaul »

Again, really impressed that this stock CR-10, with no really big tweaks (strain relief and bigger bed leveling knobs...) is doing so well.

I really wish Ultimaker offered a large scale machine. But at $380 and these sorts of results...I could buy 10 CR-10's for the cost of their best printer!
Post Reply

Return to “Creality Large Scale 3D Printers”