More great prints !

Creality CR-10 series 3D printers
Post Reply
User avatar
LePaul
Reactions:
Posts: 3099
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): Ultimaker 2+, FT-5, CR-10, CR-10S, Tevo Tornado
Contact:

More great prints !

Post by LePaul » October 19th, 2017, 8:09 am

I've been printing the BB-8 circular panels. Minimal support, just on the edges to aide in adhesion and then under the center and where there are openings/holes.

Simplify3D time projections are way off, but this took 49 hours.

0.2mm layer height from bottom to mid ring, then 0.1mm for the rest. 20% infill
Capture.PNG

User avatar
LePaul
Reactions:
Posts: 3099
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): Ultimaker 2+, FT-5, CR-10, CR-10S, Tevo Tornado
Contact:

Re: More great prints !

Post by LePaul » October 19th, 2017, 8:11 am

Again, really impressed that this stock CR-10, with no really big tweaks (strain relief and bigger bed leveling knobs...) is doing so well.

I really wish Ultimaker offered a large scale machine. But at $380 and these sorts of results...I could buy 10 CR-10's for the cost of their best printer!

Post Reply

Return to “Creality CR-10 Large Scale 3D Printer”

Who is online

Users browsing this forum: No registered users and 1 guest