Page 1 of 1

Temperature problems?

Posted: November 16th, 2018, 4:15 pm
by Emwyo
Hello guys!

I have bought a new PLA filament ( Spectrum brand ) but i have issues with printing. It's not sticking, or not melting? I do not know.
Crealiy cr-10
Slicer: cura
Already tried:
-Lowered the cooling fan speed down to 40%
-Multiple nozzle size ( 0,2 and 0,4 )
-print with 180C° - 230C°
Link for my settings:
https://imgur.com/a/5YAECeh

Re: Temperature problems?

Posted: November 16th, 2018, 9:13 pm
by LePaul
That's some serious underextrusion going on.
Which version of Cura? Download the latest

While made with the Ultimaker 3D printers in mind, this is still a useful resource
https://support.3dverkstan.se/article/2 ... ting-guide

Re: Temperature problems?

Posted: November 17th, 2018, 3:23 am
by Emwyo
Newest cura downloaded.
Thanks for the link, going to check it. :)

Re: Temperature problems?

Posted: November 18th, 2018, 8:28 am
by Emwyo
Im just tried another PLA filament which is worked well. So i guess something bad with the another PLA filament.

Re: Temperature problems?

Posted: November 18th, 2018, 10:01 am
by Roberts_Clif
I see you found your filament could have been the most likely cause, good for you. Filament problems can be a hard problem to diagnose.

If you have not already done so read the posts on this forum, there is a lot of good information to learn. An a lot of good members to learn from.
Stick around, learn the new 3D Printer innovation with us, and please post what you have learned and any problems you may come across.