CR-10 vs the CR-10S

Creality CR-10 series 3D printers
Post Reply
User avatar
LePaul
Reactions:
Posts: 2871
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): Ultimaker 2+, Folger Tech FT-5, Creality CR-10
Contact:

CR-10 vs the CR-10S

Post by LePaul » November 29th, 2017, 7:54 am

I'm curious of the gains...from what I have observed...the 10S has dual z, filament run out sensor and I *think* an MKS board, replacing the Melzie board.

However, I am told the bed heating is much slower than the original?

GrueMaster
Reactions:
Posts: 196
Joined: March 15th, 2017, 8:46 pm
Location: Oregon
3D Printer(s): HICTOP 3DP-17

Re: CR-10 vs the CR-10S

Post by GrueMaster » November 29th, 2017, 9:51 am

I have the 10S, and I know the bed heating is much slower than my 3DP-17. I thought it might be due to the 12v setup vs 24v on the 3DP-17. I'll time it this weekend and report back.

User avatar
LePaul
Reactions:
Posts: 2871
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): Ultimaker 2+, Folger Tech FT-5, Creality CR-10
Contact:

Re: CR-10 vs the CR-10S

Post by LePaul » November 29th, 2017, 12:44 pm

But you can upgrade the firmware on that one. Mine requires a new board.

Post Reply

Return to “Creality CR-10 Large Scale 3D Printer”

Who is online

Users browsing this forum: No registered users and 1 guest