Heating failed, Printer halted, Please reset.

Discussion of the Folger Tech FT-5 Large Scale 3D Printer Kit
Post Reply
Lez0
Reactions:
Posts: 12
Joined: October 8th, 2017, 10:21 am
3D Printer(s): FT-5

Heating failed, Printer halted, Please reset.

Post by Lez0 » February 12th, 2018, 2:44 am

I get this error when I am trying to heat the bed to 100°C, it happens after about 80°C.
Sometimes I don't get it for a few days, then, like yesterday it happened 5 or 6 times while heating the bed.
I have reset, switched it off and back on again, but it happens again, then it will work OK no problems.
When it is finally up to temperature it works fine.
Anybody got any ideas?

Thanks

Les

User avatar
LePaul
Reactions:
Posts: 2971
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): Ultimaker 2+, FT-5, CR-10, CR-10S, Tevo Tornado
Contact:

Re: Heating failed, Printer halted, Please reset.

Post by LePaul » February 12th, 2018, 8:46 pm

Do you have a sheet of cork under your heated bed? Are you using a MOSFET?

Post Reply

Return to “Folger Tech FT-5 Large Scale 3D Printer”

Who is online

Users browsing this forum: No registered users and 1 guest