Best part cooling fan?

Discussion of the Folger Tech Large Scale 3D Printer Kits, such as the FT-5, FT-i3 Mega, FT-6 and others
Post Reply
User avatar
Posts: 3304
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): Ultimaker 2+, FT-5, CR-10, CR-10S, Tevo Tornado

Best part cooling fan?

Post by LePaul » June 19th, 2017, 3:15 pm

I've seen a few designs out there. Most have some drawbacks, affected the Z or X axis.

The Fang design that many use for the CR-10 works well, and since it is up high, does not block the nozzle

This is a variant of the Fang but gives you an idea....

I wonder if someone is clever enough to design something like that, but perhaps it is supported/attached/linked to the slider block mount?

Post Reply

Return to “Folger Tech Large Scale 3D Printers”