FT-5 Wiring tips

Discussion of the Folger Tech FT-5 Large Scale 3D Printer Kit
Post Reply
User avatar
LePaul
Reactions:
Posts: 3018
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): Ultimaker 2+, FT-5, CR-10, CR-10S, Tevo Tornado
Contact:

FT-5 Wiring tips

Post by LePaul » February 24th, 2017, 3:10 pm

The thread is for guidance on wiring up the FT-5

User avatar
LePaul
Reactions:
Posts: 3018
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): Ultimaker 2+, FT-5, CR-10, CR-10S, Tevo Tornado
Contact:

Re: FT-5 Wiring tips

Post by LePaul » February 24th, 2017, 3:13 pm

Here's a link to the Igus wesite for cable chain wire...

http://www.igus.com/Shop/Category/30073 ... l%20cables

User avatar
Xeno
Reactions:
Posts: 109
Joined: February 12th, 2016, 6:57 am
3D Printer(s): Ultimaker original enlarged

Re: FT-5 Wiring tips

Post by Xeno » February 24th, 2017, 3:33 pm

This guide made the wiring soo much easier

FT5 Wiring Schematic

User avatar
LePaul
Reactions:
Posts: 3018
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): Ultimaker 2+, FT-5, CR-10, CR-10S, Tevo Tornado
Contact:

Re: FT-5 Wiring tips

Post by LePaul » February 26th, 2017, 12:28 pm

One of the builders reported really good results with CF240-03-18
Capture.JPG

Post Reply

Return to “Folger Tech FT-5 Large Scale 3D Printer”

Who is online

Users browsing this forum: No registered users and 1 guest