Page 1 of 1

My Review of the Ultimaker 3

Posted: June 2nd, 2017, 11:40 pm
by LePaul
Having spent a month with this printer, I thought it was time to collect my thoughts and do a review!

https://youtu.be/pl9flKbUSvs

Re: My Review of the Ultimaker 3

Posted: June 3rd, 2017, 4:28 am
by darkdvd
note for Paul : You need a microphone

Re: My Review of the Ultimaker 3

Posted: June 3rd, 2017, 7:31 am
by LePaul
I had two. Both suck

Re: My Review of the Ultimaker 3

Posted: September 6th, 2017, 9:56 am
by LePaul
Following up on this....I do miss the Ultimaker 3. The autolevel and PVA supports were really great. The size was a bit disappointing, since my BB-8 pieces were just a bit larger than the available print volume. (Wider...)

Knowing that Cura now has that Support Interface Layer, to use less PVA, would be great to try out.