My Review of the Ultimaker 3

The dual extruding Ultimaker 3!
Post Reply
User avatar
LePaul
Reactions:
Posts: 3963
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): 24 - Yes I have a problem!
Contact:

My Review of the Ultimaker 3

Post by LePaul »

Having spent a month with this printer, I thought it was time to collect my thoughts and do a review!

https://youtu.be/pl9flKbUSvs
User avatar
darkdvd
Reactions:
Posts: 53
Joined: February 27th, 2016, 6:01 am
Location: France
3D Printer(s): UM2/UM2+

Re: My Review of the Ultimaker 3

Post by darkdvd »

note for Paul : You need a microphone
User avatar
LePaul
Reactions:
Posts: 3963
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): 24 - Yes I have a problem!
Contact:

Re: My Review of the Ultimaker 3

Post by LePaul »

I had two. Both suck
User avatar
LePaul
Reactions:
Posts: 3963
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): 24 - Yes I have a problem!
Contact:

Re: My Review of the Ultimaker 3

Post by LePaul »

Following up on this....I do miss the Ultimaker 3. The autolevel and PVA supports were really great. The size was a bit disappointing, since my BB-8 pieces were just a bit larger than the available print volume. (Wider...)

Knowing that Cura now has that Support Interface Layer, to use less PVA, would be great to try out.
Post Reply

Return to “Ultimaker 3 / Ultimaker 3 Extended”