My Review of the Ultimaker 3

The dual extruding Ultimaker 3!
Post Reply
User avatar
LePaul
Reactions:
Posts: 2872
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): Ultimaker 2+, Folger Tech FT-5, Creality CR-10
Contact:

My Review of the Ultimaker 3

Post by LePaul » June 2nd, 2017, 11:40 pm

Having spent a month with this printer, I thought it was time to collect my thoughts and do a review!

https://youtu.be/pl9flKbUSvs

User avatar
darkdvd
Reactions:
Posts: 52
Joined: February 27th, 2016, 6:01 am
Location: France
3D Printer(s): UM2/UM2+

Re: My Review of the Ultimaker 3

Post by darkdvd » June 3rd, 2017, 4:28 am

note for Paul : You need a microphone
"Qui ne connaît pas l'histoire ne connaît rien"
Edward johnston, 1990

User avatar
LePaul
Reactions:
Posts: 2872
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): Ultimaker 2+, Folger Tech FT-5, Creality CR-10
Contact:

Re: My Review of the Ultimaker 3

Post by LePaul » June 3rd, 2017, 7:31 am

I had two. Both suck

User avatar
LePaul
Reactions:
Posts: 2872
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): Ultimaker 2+, Folger Tech FT-5, Creality CR-10
Contact:

Re: My Review of the Ultimaker 3

Post by LePaul » September 6th, 2017, 9:56 am

Following up on this....I do miss the Ultimaker 3. The autolevel and PVA supports were really great. The size was a bit disappointing, since my BB-8 pieces were just a bit larger than the available print volume. (Wider...)

Knowing that Cura now has that Support Interface Layer, to use less PVA, would be great to try out.

Post Reply

Return to “Ultimaker 3 / Ultimaker 3 Extended”

Who is online

Users browsing this forum: No registered users and 1 guest