Wifi ?

The dual extruding Ultimaker 3!
Post Reply
User avatar
LePaul
Reactions:
Posts: 3963
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): 24 - Yes I have a problem!
Contact:

Wifi ?

Post by LePaul »

So both printers aren't able to be seen on my laptop on Cura or my app

I haven't tried going through the setup again

The wifi/local LAN is DHCP....is it normal for these fellas to drop off the network?
nallath
Reactions:
Posts: 267
Joined: February 16th, 2016, 3:12 am
3D Printer(s): Ultimaker

Re: Wifi ?

Post by nallath »

If you manualy connect to them, are they reachable?
User avatar
LePaul
Reactions:
Posts: 3963
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): 24 - Yes I have a problem!
Contact:

Re: Wifi ?

Post by LePaul »

Well what's interesting is they are showing IPs and when I enter that into the app, I still can not connect to them

I haven't touched my Netgear router, are there any settings I need to make?

The reason I ask is I've never had to intervene. The laser printers are on the DHCP LAN and never fallen off like this
Post Reply

Return to “Ultimaker 3 / Ultimaker 3 Extended”