NFC scan plug port

The dual extruding Ultimaker 3!
User avatar
Neotko
Reactions:
Posts: 1142
Joined: February 7th, 2016, 7:02 pm
Location: Madrid
3D Printer(s): UMO+ x2.5
Contact:

Re: NFC scan plug port

Post by Neotko » May 15th, 2017, 2:23 am

I supposed you did that, isn't that explained on the a4 paper of first steps to do?

User avatar
LePaul
Reactions:
Posts: 3078
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): Ultimaker 2+, FT-5, CR-10, CR-10S, Tevo Tornado
Contact:

Re: NFC scan plug port

Post by LePaul » May 15th, 2017, 1:51 pm

No it is not on the first steps sheet.

User avatar
LePaul
Reactions:
Posts: 3078
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): Ultimaker 2+, FT-5, CR-10, CR-10S, Tevo Tornado
Contact:

Re: NFC scan plug port

Post by LePaul » May 15th, 2017, 1:52 pm

What's interesting is it worked for a while then stopped working. Looks like recalibrating worked

Post Reply

Return to “Ultimaker 3 / Ultimaker 3 Extended”

Who is online

Users browsing this forum: No registered users and 4 guests