Anyone experiment with Klipper?

Wireless/network connectivity to print, control and monitor prints!
Post Reply
User avatar
GrueMaster
Reactions:
Posts: 522
Joined: March 15th, 2017, 8:46 pm
Location: Oregon
3D Printer(s): Hictop 3DP-17, Hictop CR-10S

Anyone experiment with Klipper?

Post by GrueMaster »

I found a link to this firmware/software combination on the CR-10 discussions on Thingiverse. Looks interesting.
https://github.com/KevinOConnor/klipper

I may try it out on my little-hicci later (copious spare time and all), since I have the Marlin firmware and a complete replacement board if things go south. The software side sits below Octoprint (hence why I posted in this section).
Post Reply

Return to “Wireless Printing and Controllers”