Anyone experiment with Klipper?

Wireless/network connectivity to print, control and monitor prints!
Post Reply
Posts: 262
Joined: March 15th, 2017, 8:46 pm
Location: Oregon
3D Printer(s): HICTOP 3DP-17

Anyone experiment with Klipper?

Post by GrueMaster » January 11th, 2018, 12:16 am

I found a link to this firmware/software combination on the CR-10 discussions on Thingiverse. Looks interesting.

I may try it out on my little-hicci later (copious spare time and all), since I have the Marlin firmware and a complete replacement board if things go south. The software side sits below Octoprint (hence why I posted in this section).

Post Reply

Return to “Wireless Printing and Controllers”

Who is online

Users browsing this forum: No registered users and 1 guest