Wifi failure on Pi3 ?

Wireless/network connectivity to print, control and monitor prints!
Post Reply
User avatar
LePaul
Reactions:
Posts: 2971
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): Ultimaker 2+, FT-5, CR-10, CR-10S, Tevo Tornado
Contact:

Wifi failure on Pi3 ?

Post by LePaul » January 25th, 2018, 9:31 pm

I'm curious if this is a know problem...what's weird is mine was working as recently as a few days ago.

Not showing up on network. Power cycle, green light eventually goes away, leaving just the red illuminated. Green will come and go but largely stay off.

Only thing of importance was there was a network outage yesterday and modem/routers were power cycled....but that shouldn't affect anything.

User avatar
LePaul
Reactions:
Posts: 2971
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): Ultimaker 2+, FT-5, CR-10, CR-10S, Tevo Tornado
Contact:

Re: Wifi failure on Pi3 ?

Post by LePaul » January 25th, 2018, 9:36 pm

After a lot of searches....the theme seems to be SD Card failure can cause issues with Pi

However I can read the card fine? I formatted it and re-imaged...problem persists. Looks like a new SD card is needed

Post Reply

Return to “Wireless Printing and Controllers”

Who is online

Users browsing this forum: No registered users and 1 guest