Loading by hostname instead of IP?

Wireless/network connectivity to print, control and monitor prints!
Post Reply
User avatar
LePaul
Reactions:
Posts: 2792
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): Ultimaker 2+, Folger Tech FT-5, Creality CR-10
Contact:

Loading by hostname instead of IP?

Post by LePaul » July 15th, 2017, 4:20 pm

I'm searching around but not finding it....but if I do, I'll share....

In the Octoprint setup (web interface), I changed the Appearance setting title so I know which device I have connected to ("Ultimaker 2+" or "Creality CR-10")

I can connect find via IP but I would like to use the hostname. I can't seem to find a good way to do that. I see some posts about local DNS and other extensive network settings

User avatar
LePaul
Reactions:
Posts: 2792
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): Ultimaker 2+, Folger Tech FT-5, Creality CR-10
Contact:

Re: Loading by hostname instead of IP?

Post by LePaul » July 15th, 2017, 4:26 pm


Post Reply

Return to “Wireless Printing and Controllers”

Who is online

Users browsing this forum: No registered users and 1 guest