Controller Freezes

Have a problem or question, suggested links/information/FAQ's? Post it here
User avatar
Roberts_Clif
Reactions:
Posts: 1372
Joined: March 25th, 2017, 8:17 am
Location: Washington, State USA
3D Printer(s): Hictop 3DP11/12

Re: Controller Freezes

Post by Roberts_Clif »

I like, and have downloaded lots but did not like them. and have not had time to use Fusion 360 for my own design.

I have wanted the display off the top for a long time. I believe i get noise from the controller the interferes with the SD card.

Did you ever try my Snap together Controller case.

thank you.
User avatar
GrueMaster
Reactions:
Posts: 522
Joined: March 15th, 2017, 8:46 pm
Location: Oregon
3D Printer(s): Hictop 3DP-17, Hictop CR-10S

Re: Controller Freezes

Post by GrueMaster »

No, because my controller is in a metal case already. I have it, just haven't had the need to use it.
User avatar
Roberts_Clif
Reactions:
Posts: 1372
Joined: March 25th, 2017, 8:17 am
Location: Washington, State USA
3D Printer(s): Hictop 3DP11/12

Re: Controller Freezes

Post by Roberts_Clif »

That's correct! I remember now! we Forget the small things sometimes.
User avatar
Roberts_Clif
Reactions:
Posts: 1372
Joined: March 25th, 2017, 8:17 am
Location: Washington, State USA
3D Printer(s): Hictop 3DP11/12

Re: Controller Freezes

Post by Roberts_Clif »

Found my problem. My new MPX.3 Backup controller from Hictop is Bad. Replaced with the Original Base v1.3 controller Flashed Marlin 1.1.5 worked perfect. Contacted Hictop will not talk to me, will not message me.

Printed the LCD case for Blu. Now will do some testing to see if any problems arise.
Printing a pop bottle bird feeder on my New Surface from Hictop Rep so far only build surface that has worked besides Vinyl transfer Paper Tape.

LCD front.jpg

I like the Front LCD though, have not officially decided if I like the LCD style or not. Believe may re-mix it and post here for others.
User avatar
Roberts_Clif
Reactions:
Posts: 1372
Joined: March 25th, 2017, 8:17 am
Location: Washington, State USA
3D Printer(s): Hictop 3DP11/12

Re: Controller Freezes

Post by Roberts_Clif »

Last note on the blog, Contacted manufacture they agreed to replace controller under warranty.
Replacement has been shipped and will arrive here when is can pass thru U.S. Customs.
Post Reply

Return to “General Questions”