Initial power on all steppers move one direction for a second then reverse for a second
Posted: December 31st, 2016, 9:12 pm
I just built the Hictop 3DP-11-AT, upon initial power on all the stepper motors move one direction for about a second then reverse motion. The cooling fans also rev up and slow down in similar fashion, the heated build platform heats up automatically as well....what is going on? I've let it run for about a minute and just turned it off.
The LCD does power on and I do get temp readings, any idea or suggestions would be appreciated. I can't seem to find the firmware for this printer either.
Thanks!
The LCD does power on and I do get temp readings, any idea or suggestions would be appreciated. I can't seem to find the firmware for this printer either.
Thanks!