Re: Need a bit of help deciding on upgrade or new
Posted: February 9th, 2019, 8:22 pm
I couldn't help myself and started to rebuild as much as I can whilst waiting for the other parts to arrive and makesure that everything is squared up correctly. Replaced all the bearings with Drylin bearings apart from the new z-axis ones.
Is it possible to load your marlin firmware with the SN04 sensor not being plugged in yet and still use the printer so I can print out the upgrade parts like the case and y-axis stop mount etc ?
If it is possible where can I download it from as I can't seem to find a download area on the forum unless I am being totally blind.
The only things I have changed so far is the bearings and put the Z-axis lead screw upgrade from hictop on, and changed out the heated bed cable to better silicone wire.
If there is anything that you would recommend doing before I install the new firmware and printing out the new parts please let me know. I don't want to try and home the printer yet without the new firmware just incase of something crashing.
Is it possible to load your marlin firmware with the SN04 sensor not being plugged in yet and still use the printer so I can print out the upgrade parts like the case and y-axis stop mount etc ?
If it is possible where can I download it from as I can't seem to find a download area on the forum unless I am being totally blind.
The only things I have changed so far is the bearings and put the Z-axis lead screw upgrade from hictop on, and changed out the heated bed cable to better silicone wire.
If there is anything that you would recommend doing before I install the new firmware and printing out the new parts please let me know. I don't want to try and home the printer yet without the new firmware just incase of something crashing.