Yes, just showing off my 3DP-08 printer mods for you guys
So i gotta say i am still not regretting my purchase of this cheap printer at all.
I still think its a great way to learn how printers work and become good at it.
So my mods? Not that many.
E3Dv6 full hot end
Mk7 Drive Gear
Relocated spool holder
Hic Inductive Sensor for ABL
Power switch added
LED strips for better lighting
Adjustable X belt tensioner
Adjustable Y belt tensioner
Cable chain and wire tuck
128 x 64 Full Graphics Display
I tried to reuse as many parts as possible. So far i am enjoying it!
integrating the lead screws to the Y motors.
Maybe a new motherboard?
PS. Benchy included, because why not?
Share your hardware improvements for your HIC i3, the good and the bad!
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest