Page 1 of 1
Added E3D hotend and bowden extruder - now it won't center
Posted: October 17th, 2018, 8:57 pm
by Shazam0527
From first glance of my old direct drive and Hictop hotend, it looks like it lines up. But for the life of me, I cannot figure out why my print head won't center now when using the "Auto Home" on the printer.
Can anyone give me some suggestions?
Re: Added E3D hotend and bowden extruder - now it won't center
Posted: October 18th, 2018, 7:43 am
by Roberts_Clif
What firmware are you using.
Post a link to your new configuration.h settings, with the added information we may be able to help you!
Re: Added E3D hotend and bowden extruder - now it won't center
Posted: October 18th, 2018, 9:32 am
by LePaul
Yes
As he said, give us details.
Re: Added E3D hotend and bowden extruder - now it won't center
Posted: October 18th, 2018, 4:32 pm
by Shazam0527
I'm using what came with it - unfortunately that part of configuration I'm very unfamiliar (read noob) with. Does it involve changing the configuration.h settings? Ugh, not even sure where to start with that part.
Re: Added E3D hotend and bowden extruder - now it won't center
Posted: October 18th, 2018, 4:33 pm
by Shazam0527
After looking at and measuring where the old head was and the new head is.. there is a 16mm difference on the X axis. Would it be safer for me to just use the G92 setting in gcode?