3D Printer RAMPS 1.4 SD Card Reader

Software and Firmware Discussion - related to source code, firmware updates, etc.
Post Reply
User avatar
Posts: 396
Joined: March 25th, 2017, 8:17 am
Location: Washington
3D Printer(s): Hictop 3DP11/12

3D Printer RAMPS 1.4 SD Card Reader

Post by Roberts_Clif » December 24th, 2017, 1:56 pm

I have purchased replacement 3D Printer RAMPS 1.4 SD Card Reader and need some help.

I have a Ramps 1.4 compatible controller and a RepRapDiscount Smart Controller working.

Asking for help to remove the LCD on board SD card Reader and Be able to connect the 3D Printer RAMPS 1.4 SD Card Reader.
What I Know.

Supports Voltage:4.5 to 5.5V
SPI Mode
Sits Directly on a RAMPS
Electronics Technician / Computer Programmer

Sometimes the correct answer if not essential to a solution.
If the information provided indirectly leads you to a solution.

Post Reply

Return to “Software and Firmware Discussion”

Who is online

Users browsing this forum: No registered users and 4 guests