Updating Stock HICTOP 3DP-11-ATL to Latest Marlin and Changing Bed Leveling Sensor

Software and Firmware Discussion - related to source code, firmware updates, etc.
kgrigio
Reactions:
Posts: 19
Joined: December 3rd, 2017, 10:33 pm
3D Printer(s): HICTOP 3DP-11-ATL

Re: Updating Stock HICTOP 3DP-11-ATL to Latest Marlin and Changing Bed Leveling Sensor

Post by kgrigio » December 21st, 2017, 5:49 pm

Here is the link to the page that discusses the sensor

https://miscsolutions.wordpress.com/min ... sor-board/

and here is the link to the site that is referenced in the above site for where you can purchase the sensor if you are in the US

https://www.filastruder.com/products/mi ... ght-sensor

Post Reply

Return to “Software and Firmware Discussion”

Who is online

Users browsing this forum: No registered users and 2 guests