Settings tutorial
Settings tutorial
Is there a good tutorial or explanation of all of the little settings in the firmware, stuff like steps and all that?
- Roberts_Clif
- Reactions:
- Posts: 1380
- Joined: March 25th, 2017, 8:17 am
- Location: Washington, State USA
- 3D Printer(s): Hictop 3DP11/12
Re: Settings tutorial
Unfortunately I do not believe there is just one, if there is it is well hidden. I believe you will have to read many.
None of these articles cover any area to a thorough explanation, they get to the point they want to make and stop.
This is some of the better articles.
http://www.instructables.com/id/Motion- ... lin-firmw/
http://marlinfw.org/meta/configuration/
http://solidutopia.com/marlin-firmware- ... ide-basic/
http://reprap.org/wiki/Triffid_Hunter's ... tion_Guide
http://reprapandme.blogspot.com/
My Bookmark folder in Firefox includes 100 sub categories and growing on a daily basis.
None of these articles cover any area to a thorough explanation, they get to the point they want to make and stop.
This is some of the better articles.
http://www.instructables.com/id/Motion- ... lin-firmw/
http://marlinfw.org/meta/configuration/
http://solidutopia.com/marlin-firmware- ... ide-basic/
http://reprap.org/wiki/Triffid_Hunter's ... tion_Guide
http://reprapandme.blogspot.com/
My Bookmark folder in Firefox includes 100 sub categories and growing on a daily basis.