Settings tutorial

Software and Firmware Discussion - related to source code, firmware updates, etc.
Post Reply
boiler02
Reactions:
Posts: 35
Joined: September 3rd, 2017, 10:15 pm

Settings tutorial

Post by boiler02 » September 11th, 2017, 10:11 pm

Is there a good tutorial or explanation of all of the little settings in the firmware, stuff like steps and all that?

User avatar
Roberts_Clif
Reactions:
Posts: 432
Joined: March 25th, 2017, 8:17 am
Location: Washington
3D Printer(s): Hictop 3DP11/12

Re: Settings tutorial

Post by Roberts_Clif » September 12th, 2017, 8:33 am

Unfortunately I do not believe there is just one, if there is it is well hidden. I believe you will have to read many.

None of these articles cover any area to a thorough explanation, they get to the point they want to make and stop.
This is some of the better articles.

http://www.instructables.com/id/Motion- ... lin-firmw/
http://marlinfw.org/meta/configuration/
http://solidutopia.com/marlin-firmware- ... ide-basic/
http://reprap.org/wiki/Triffid_Hunter's ... tion_Guide
http://reprapandme.blogspot.com/

My Bookmark folder in Firefox includes 100 sub categories and growing on a daily basis.
Electronics Technician / Computer Programmer

Post Reply

Return to “Software and Firmware Discussion”

Who is online

Users browsing this forum: No registered users and 5 guests