It was released May 4th. Has anyone else downloaded it yet?
I have a clone of the tree. Will try to look at it in the next few days. Lots of changes since RC8.
Marlin 1.1 is out!
- GrueMaster
- Reactions:
- Posts: 522
- Joined: March 15th, 2017, 8:46 pm
- Location: Oregon
- 3D Printer(s): Hictop 3DP-17, Hictop CR-10S
- drayson
- Reactions:
- Posts: 254
- Joined: February 15th, 2016, 5:04 am
- Location: Graz, Austria
- 3D Printer(s): UMO with mods :-)
Re: Marlin 1.1 is out!
jupp - there seems to be a lot of reork in it - especially compared with the "old" release.
Downloaded it, but not uploaded/tested it up to now on my UMO.
From my point of view, one key feature is still missing: move away the printhead when klicking on "stop" in menue..
But a behavior for "pause" should be in now...
What I like is the sorting of the SD card content alphabetical.
we will see how usable it is...
Downloaded it, but not uploaded/tested it up to now on my UMO.
From my point of view, one key feature is still missing: move away the printhead when klicking on "stop" in menue..
But a behavior for "pause" should be in now...
What I like is the sorting of the SD card content alphabetical.
we will see how usable it is...
- Chaco
- Reactions:
- Posts: 53
- Joined: September 12th, 2016, 6:48 pm
- Location: OH
- 3D Printer(s): HyperCube & Hictop Prusa i3 3DP-08
- Contact:
Re: Marlin 1.1 is out!
i downloaded it last month, edited my settings, compiled it, and its been working great so far.
- drayson
- Reactions:
- Posts: 254
- Joined: February 15th, 2016, 5:04 am
- Location: Graz, Austria
- 3D Printer(s): UMO with mods :-)
Re: Marlin 1.1 is out!
there is already an update - 1.1.3
unfortunately I did something wrong with setup so my UMO makes strange things (does not home propperly, ignores endstops...)
unfortunately I did something wrong with setup so my UMO makes strange things (does not home propperly, ignores endstops...)
- LePaul
- Reactions:
- Posts: 3966
- Joined: February 7th, 2016, 10:26 pm
- Location: Bangor, Maine USA
- 3D Printer(s): 24 - Yes I have a problem!
- Contact:
Re: Marlin 1.1 is out!
Oh that's not good
- drayson
- Reactions:
- Posts: 254
- Joined: February 15th, 2016, 5:04 am
- Location: Graz, Austria
- 3D Printer(s): UMO with mods :-)
Re: Marlin 1.1 is out!
tried to setup comletely new with a new downloaded version.
honestly, I have no idea what happens...
Z reading shows a "?" at the display, when trying to home via G28 it makes a short movement, seems to ignore the endstops.
crosschecked twice to set the same values/definition as in my working version.
Any hint is appreciated...
honestly, I have no idea what happens...
Z reading shows a "?" at the display, when trying to home via G28 it makes a short movement, seems to ignore the endstops.
crosschecked twice to set the same values/definition as in my working version.
Any hint is appreciated...