Marlin 1.1 is out!

Software and Firmware Discussion - related to source code, firmware updates, etc.
Post Reply
User avatar
GrueMaster
Reactions:
Posts: 522
Joined: March 15th, 2017, 8:46 pm
Location: Oregon
3D Printer(s): Hictop 3DP-17, Hictop CR-10S

Marlin 1.1 is out!

Post by GrueMaster »

It was released May 4th. Has anyone else downloaded it yet?

I have a clone of the tree. Will try to look at it in the next few days. Lots of changes since RC8.
User avatar
drayson
Reactions:
Posts: 254
Joined: February 15th, 2016, 5:04 am
Location: Graz, Austria
3D Printer(s): UMO with mods :-)

Re: Marlin 1.1 is out!

Post by drayson »

jupp - there seems to be a lot of reork in it - especially compared with the "old" release.

Downloaded it, but not uploaded/tested it up to now on my UMO.
From my point of view, one key feature is still missing: move away the printhead when klicking on "stop" in menue..
But a behavior for "pause" should be in now...
What I like is the sorting of the SD card content alphabetical.

we will see how usable it is... :-)
User avatar
Chaco
Reactions:
Posts: 53
Joined: September 12th, 2016, 6:48 pm
Location: OH
3D Printer(s): HyperCube & Hictop Prusa i3 3DP-08
Contact:

Re: Marlin 1.1 is out!

Post by Chaco »

i downloaded it last month, edited my settings, compiled it, and its been working great so far.
User avatar
drayson
Reactions:
Posts: 254
Joined: February 15th, 2016, 5:04 am
Location: Graz, Austria
3D Printer(s): UMO with mods :-)

Re: Marlin 1.1 is out!

Post by drayson »

there is already an update - 1.1.3
unfortunately I did something wrong with setup so my UMO makes strange things (does not home propperly, ignores endstops...)
User avatar
LePaul
Reactions:
Posts: 3963
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): 24 - Yes I have a problem!
Contact:

Re: Marlin 1.1 is out!

Post by LePaul »

Oh that's not good
User avatar
drayson
Reactions:
Posts: 254
Joined: February 15th, 2016, 5:04 am
Location: Graz, Austria
3D Printer(s): UMO with mods :-)

Re: Marlin 1.1 is out!

Post by drayson »

tried to setup comletely new with a new downloaded version.
honestly, I have no idea what happens...

Z reading shows a "?" at the display, when trying to home via G28 it makes a short movement, seems to ignore the endstops.
crosschecked twice to set the same values/definition as in my working version.

Any hint is appreciated... :-(
Post Reply

Return to “Software and Firmware Discussion”