Thanks to Chip Luck and other threads on this board (
viewtopic.php?f=51&t=189), I have the RCBugFix branch (as of 8/7/16) compiled and working for my 3DP-18 (which is a little different than some of the other models from HICTOP, but maybe the same as the 3DP-16). Here are some resources that might help other folks with a 3DP-18 model.
My Configuration.h file differences:
https://github.com/glickbot/Marlin/comm ... 51c6fd7948
The branch that I'll be updating (until I start tinkering with the z probe)
https://github.com/glickbot/Marlin/tree ... 8/NoZProbe
Hex Code ( feels kinda like trading underwear... but hey ):
Marlin Code (From HICTOP, really old, but what I used for some baseline config parameters):
Also, my avrdude backup from my 3DP-18 before I tinkered with the firmare ( I've not tested reloading it ):
The commands I used to backup my firmware with AVRDUDE on an Octopi:
Code: Select all
avrdude -p atmega2560 -b 115200 -c wiring -P /dev/ttyUSB0 -U flash:r:factory_hictop_3DP18.hex:i
avrdude -p atmega2560 -b 115200 -c wiring -P /dev/ttyUSB0 -U eeprom:r:eeprom_hictop_3DP18.hex:i
Also, random note, the 3DP-18 uses a different power supply than other HICTOPs, mine went out a few days ago, so I hastily bought a 360-12 (12v) as mentioned on this board... but it didn't work with my 3DP-18, I needed a 360-24 (24v). HICTOP has said they'll be sending a new one ( since I just bought this recently ), so I'm very grateful about that. Anyway, I've been meaning to get this stuff up here since the resources on this board have been so helpful to me, so here's what I have, sorry they're a bit disorganized.