HIC i3 - current firmware development information
-
- Reactions:
- Posts: 51
- Joined: February 21st, 2017, 2:42 pm
- 3D Printer(s): FFCP, HICTOP i3
Re: HIC i3 - current firmware development information
I have Marlin 1.1.3 and 1.1.5 on a variety of Hictop printers. Some are MPX.3 and some V1.3. I have not seen this issue at all. I did get G28 Z forbidden before, but that was due to having Safe Homing turned on when I was trying to home Z at another location.
- Roberts_Clif
- Reactions:
- Posts: 1380
- Joined: March 25th, 2017, 8:17 am
- Location: Washington, State USA
- 3D Printer(s): Hictop 3DP11/12
Re: HIC i3 - current firmware development information
Maybe that is why I get it, I Have safe homing turned on.shocksofmighty wrote: ↑September 17th, 2017, 8:18 am I have Marlin 1.1.3 and 1.1.5 on a variety of Hictop printers. Some are MPX.3 and some V1.3. I have not seen this issue at all. I did get G28 Z forbidden before, but that was due to having Safe Homing turned on when I was trying to home Z at another location.
- Roberts_Clif
- Reactions:
- Posts: 1380
- Joined: March 25th, 2017, 8:17 am
- Location: Washington, State USA
- 3D Printer(s): Hictop 3DP11/12
Re: HIC i3 - current firmware development information
It Appears that the "G28 Z Forbidden" is given when you home Z while At Home.
While using OctoPrint If I am at home and home Z in OctoPrint I get the "G28 Z Forbidden".
If I first home XY and then home Z in OctoPrint it works fine.
While using OctoPrint If I am at home and home Z in OctoPrint I get the "G28 Z Forbidden".
If I first home XY and then home Z in OctoPrint it works fine.