HIC i3 - current firmware development information

Software and Firmware Discussion - related to source code, firmware updates, etc.
shocksofmighty
Reactions:
Posts: 51
Joined: February 21st, 2017, 2:42 pm
3D Printer(s): FFCP, HICTOP i3

Re: HIC i3 - current firmware development information

Post by shocksofmighty » September 17th, 2017, 8:18 am

I have Marlin 1.1.3 and 1.1.5 on a variety of Hictop printers. Some are MPX.3 and some V1.3. I have not seen this issue at all. I did get G28 Z forbidden before, but that was due to having Safe Homing turned on when I was trying to home Z at another location.

User avatar
Roberts_Clif
Reactions:
Posts: 403
Joined: March 25th, 2017, 8:17 am
Location: Washington
3D Printer(s): Hictop 3DP11/12

Re: HIC i3 - current firmware development information

Post by Roberts_Clif » September 17th, 2017, 9:14 am

shocksofmighty wrote:
September 17th, 2017, 8:18 am
I have Marlin 1.1.3 and 1.1.5 on a variety of Hictop printers. Some are MPX.3 and some V1.3. I have not seen this issue at all. I did get G28 Z forbidden before, but that was due to having Safe Homing turned on when I was trying to home Z at another location.
Maybe that is why I get it, I Have safe homing turned on.
Electronics Technician / Computer Programmer

Post Reply

Return to “Software and Firmware Discussion”

Who is online

Users browsing this forum: No registered users and 5 guests