Matterhacker Pro Series PETG on an Ultimaker 2+

Doesn't fit a specific category here? Place it here!
User avatar
LePaul
Reactions:
Posts: 3372
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): UM2+,CR-10S (x2),Tevo Tornado,FT-i3/FT-5/FT-6...
Contact:

Matterhacker Pro Series PETG on an Ultimaker 2+

Post by LePaul » July 9th, 2018, 9:27 pm

Anyone used it?

I was advised to use the CPE setting in Cura and on the Ultimaker control panel when loading it.

Just curious if anyone has used it, had some suggestions, fan settings, etc

Return to “General Filament & Nozzle chat”