Changing nozzles and shell thickness
Posted: March 17th, 2016, 2:15 pm
Toying around in Cura, I noticed when I changed the nozzle size (Under Advanced) to 0.6, the Shell Thickness turned yellow, indicating that should be changed.
It didn't offer me a tip/solution on what should be used as it does in most areas when hovered over
I have some large prints to do in the future and curious if a 0.6 mm nozzle is suitable for 0.2 layer height prints?
It didn't offer me a tip/solution on what should be used as it does in most areas when hovered over
I have some large prints to do in the future and curious if a 0.6 mm nozzle is suitable for 0.2 layer height prints?