Regenerating drying bags

Doesn't fit a specific category here? Place it here!
User avatar
Posts: 214
Joined: February 15th, 2016, 5:04 am
Location: Graz, Austria
3D Printer(s): UMO with mods :-)

Re: Regenerating drying bags

Postby drayson » March 5th, 2016, 11:37 am

So a dehydrator might be better for filament :-) know that my mom has such a thing in her basement...
damn.. so much opportunities of doing "the right" things....

Posts: 74
Joined: February 24th, 2016, 6:10 am
3D Printer(s): UMOriginal - UM2Go

Re: Regenerating drying bags

Postby PeggyB » March 6th, 2016, 7:41 am

so...then give your mom a visit... ;-)

Posts: 118
Joined: April 21st, 2016, 5:29 pm
Location: Salford, United Kingdom
3D Printer(s): Ultimaker 2

Re: Regenerating drying bags

Postby danilius » April 21st, 2016, 5:35 pm

Hi, been lurking for a while, so hello everyone.

I dry my silica by putting it in the microwave for around 3 minutes in a pyrex dish, and then leave it to cool down with the lid off. Usual caveats apply.

Return to “General Filament & Nozzle chat”

Who is online

Users browsing this forum: No registered users and 1 guest