Completely off Topic today

Anything you want to chat about...it doesn't have to be related to 3D printing!
User avatar
Roberts_Clif
Reactions:
Posts: 1018
Joined: March 25th, 2017, 8:17 am
Location: Washington
3D Printer(s): Hictop 3DP11/12

Completely off Topic today

Post by Roberts_Clif »

This weekend I will be tearing out the dinning room carpet, and replacing it with lament flooring.

Will also be repairing the composition roofing, over the last few winters a few roofing tab have broken off.
And I need to replace the bathroom roof vent as when it was installed it was done as a temporary solution fix.

And as every weekend I still have the normal yard waste to clean up filling two 60 gallon garbage buckets.

I believe the total of this weekends work will fill my five 60 gallon garbage buckets.
This weekends work load will take up most of my relaxing 3D Printer forum pleasure postponing it until Monday morning.

So will return to the forums again on Monday morning June 8th and see if anyone needs any help then...

And as a side note this is my one thousandth post.
Last edited by Roberts_Clif on June 7th, 2020, 8:58 am, edited 1 time in total.
Electronics Technician / Computer Programmer

User avatar
Roberts_Clif
Reactions:
Posts: 1018
Joined: March 25th, 2017, 8:17 am
Location: Washington
3D Printer(s): Hictop 3DP11/12

Re: Completely off Topic today

Post by Roberts_Clif »

Finished the dinning room floor lament flooring.
Electronics Technician / Computer Programmer

User avatar
LePaul
Reactions:
Posts: 3496
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): UM2+,CR-10S (x2),Tevo Tornado,FT-i3/FT-5/FT-6...
Contact:

Re: Completely off Topic today

Post by LePaul »

That’s quite the Honey Do List

User avatar
Roberts_Clif
Reactions:
Posts: 1018
Joined: March 25th, 2017, 8:17 am
Location: Washington
3D Printer(s): Hictop 3DP11/12

Re: Completely off Topic today

Post by Roberts_Clif »

Actually that was the short list.
Electronics Technician / Computer Programmer

Post Reply

Return to “Off Topics!”