Page 1 of 1

Tinker_16.01 problem

Posted: March 3rd, 2016, 6:28 am
by darkdvd
Hi !
Little problem with Tinker_16.01 firmaware on two UM2 : sometimes, the LCD freeze during print. button is working but the LCD is completly freeze.
Two times today on the two printers : one with a 3 hours print, one on a 13 hours print (oups).
During this time, the printers continue to print without problem....

David

(note : my french is better than my English...)

Re: Tinker_16.01 problem

Posted: March 3rd, 2016, 9:54 am
by darkdvd
Strange but the LCD screen is working now ! 07:29 left (freezing at 10:34 left)

Re: Tinker_16.01 problem

Posted: March 3rd, 2016, 10:32 am
by martin-bienz
So it's probably a lcd update issue "only" as the printer continues to print? I am sure he will fix this :)

Re: Tinker_16.01 problem

Posted: March 3rd, 2016, 12:42 pm
by darkdvd
This is not a big problem: the print ends perfectly, as an UMO without LCD PANEL!

Re: Tinker_16.01 problem

Posted: March 3rd, 2016, 12:53 pm
by Neotko
Maybe it's cross talking. Separate the lcd cables and fix them a bit away with some blue tape.

Re: Tinker_16.01 problem

Posted: March 3rd, 2016, 1:44 pm
by darkdvd
:shock:
Neotko wrote:Maybe it's cross talking. Separate the lcd cables and fix them a bit away with some blue tape.
Same problem with two UM2 ?

Re: Tinker_16.01 problem

Posted: March 3rd, 2016, 1:57 pm
by Neotko
It happens sometimes on one of my umo+ (Same board different screen) screen banishes. But only sometimes (like one in a month). Much less since I separated the cables.

Re: Tinker_16.01 problem

Posted: March 3rd, 2016, 2:17 pm
by darkdvd
OK, I understand.
I'll do a downgrade of firmware as a test, as requested me tinkergnome.
But for me, the same problem on two UM2, it's software, not hardware.

Re: Tinker_16.01 problem

Posted: March 23rd, 2016, 5:05 pm
by TinkerGnome
It seems that it happens with the standard firmware too:

Screen/Input Freezing But Still Printing

...hmmmm rushour on the I2C bus...? Arduino experts present?