Marlin 1.1.9 full menus

Topics related to printer firmware
Post Reply
User avatar
LePaul
Reactions:
Posts: 3416
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): UM2+,CR-10S (x2),Tevo Tornado,FT-i3/FT-5/FT-6...
Contact:

Marlin 1.1.9 full menus

Post by LePaul » April 4th, 2019, 10:29 pm

It looks like the default is the simple menus....but I can't find where to get EVERYTHING to show, for example the babystepping and so forth

I did make sure M500 was enabled and things like that.

But I sure hate that default short menu!

User avatar
Roberts_Clif
Reactions:
Posts: 833
Joined: March 25th, 2017, 8:17 am
Location: Washington
3D Printer(s): Hictop 3DP11/12

Re: Marlin 1.1.9 full menus

Post by Roberts_Clif » June 11th, 2019, 9:52 am

Hi LePaul

Not sure exactly what you are requesting.

Though Babystepping is in Configuration.adv.h and will display when enabled.

#define BABYSTEPPING
Electronics Technician / Computer Programmer

User avatar
LePaul
Reactions:
Posts: 3416
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): UM2+,CR-10S (x2),Tevo Tornado,FT-i3/FT-5/FT-6...
Contact:

Re: Marlin 1.1.9 full menus

Post by LePaul » June 11th, 2019, 9:58 am

Yes, I found those and got it working!
They had it off by default (FolgerTech) and after much experimenting, found it

User avatar
Roberts_Clif
Reactions:
Posts: 833
Joined: March 25th, 2017, 8:17 am
Location: Washington
3D Printer(s): Hictop 3DP11/12

Re: Marlin 1.1.9 full menus

Post by Roberts_Clif » June 11th, 2019, 5:15 pm

Thought you had though I ran across this Post and wanted to inquire.
Electronics Technician / Computer Programmer

Post Reply

Return to “Firmware”