Duet Smart Effector upgrade for BIQU Kossel plus

Discussion of ANY 3D printing topic you desire!
Post Reply
kivbob
Reactions:
Posts: 1
Joined: September 16th, 2017, 2:52 pm
3D Printer(s): BIQU Kossel Plus

Duet Smart Effector upgrade for BIQU Kossel plus

Post by kivbob »

Bought a Duet Smart Effector for my BIQU Kossel Plus 3d printer.
I am wondering what length magnetic rods (Haydn Huntley’s) are needed. The stock rods are about 335 mm center to center (ball joint). Also wondering if I should use a Duet controller or the Azteeg X5 GT controller I have.
Post Reply

Return to “General 3D Printing Conversation”