Thingiverse going the Ultimaker route - downhill :-(

Discussion of ANY 3D printing topic you desire!
reibuehl
Reactions:
Posts: 492
Joined: February 9th, 2016, 9:56 am
Location: Stuttgart, Germany
3D Printer(s): Ultimaker 2

Thingiverse going the Ultimaker route - downhill :-(

Post by reibuehl »

Looks like Thingiverse has pulled an Ultimaker move and released a new revision of their website that is a complete fail! Loading times are horrible - >1min to just open a design.

@LePaul will you take over that one too? :-D
Reiner.

User avatar
Roberts_Clif
Reactions:
Posts: 999
Joined: March 25th, 2017, 8:17 am
Location: Washington
3D Printer(s): Hictop 3DP11/12

Re: Thingiverse going the Ultimaker route - downhill :-(

Post by Roberts_Clif »

Took a few minutes to test the Thingiverse.
It took over a minute to load the main window.
Then it took over 3 minutes to load the window of the model that was selected.
And then another minute to load the download page.

This demotes to 5 minutes to download a simple model.

Second model way over 10 minutes, with disabled Add Blocker Plus thinking it caused problems.

@reibuehl are correct they have messed it up really good.
Electronics Technician / Computer Programmer

User avatar
LePaul
Reactions:
Posts: 3488
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): UM2+,CR-10S (x2),Tevo Tornado,FT-i3/FT-5/FT-6...
Contact:

Re: Thingiverse going the Ultimaker route - downhill :-(

Post by LePaul »

Yeah they made a change to their website recently and I don't know if that added to their woes.

Meanwhile MyMiniFactory works fine!

Post Reply

Return to “General 3D Printing Conversation”