Hi all
I have been using a vinyl bed surface and it works really well.
The trouble is it's hard to remove when I want to replace it, it takes ages.
I hear there are magnetic surfaces, has anyone used one, and if so does it work OK.
Thank all
Lez
Magnetic bed surface
-
- Reactions:
- Posts: 74
- Joined: January 1st, 2018, 11:02 am
- 3D Printer(s): hictop auto leveling desktop 3d printer prusa i3
Re: Magnetic bed surface
I've just bought one of these to try out, its quite cheap and can be trimmed down to fit my Hictop heatbed.
Also the adhesive sticker is made by 3M which is good quality.
Also the adhesive sticker is made by 3M which is good quality.
-
- Reactions:
- Posts: 401
- Joined: October 8th, 2017, 10:21 am
- Location: Spain
- 3D Printer(s): JGAurora A5S, Anycubic Photon, Saturn 2
Re: Magnetic bed surface
Hi Mr SNG
I have looked at these. Have you seen this?
Very informative.
Lez
I have looked at these. Have you seen this?
Very informative.
Lez
- LePaul
- Reactions:
- Posts: 3970
- Joined: February 7th, 2016, 10:26 pm
- Location: Bangor, Maine USA
- 3D Printer(s): 24 - Yes I have a problem!
- Contact:
Re: Magnetic bed surface
I just bought a magnetic build plate / spring steel sheet for my Ultimaker 2+ Goes on top of a fresh piece of glass (from Ultimaker).
https://www.printedsolid.com/products/f ... er-2-and-3
https://www.printedsolid.com/products/f ... er-2-and-3