PLA prints stick to BuildTek too much - What to do?
Posted: September 30th, 2019, 1:44 pm
Hi all,
I have applied a new BuildTek surface on my Fabrikator Mini and now have the unusual problem that my PLA prints stick way to good to it. Is there a way to make PLA stick less strong to it?
Best regards,
Reiner
I have applied a new BuildTek surface on my Fabrikator Mini and now have the unusual problem that my PLA prints stick way to good to it. Is there a way to make PLA stick less strong to it?
Best regards,
Reiner