PEI Question
Posted: July 6th, 2019, 1:30 am
Thought I would try some PEI. Bought a sheet and applied it to glass.
Directions said to preheat the bed to anywhere between 60 and 100 to smooth
it out. (Seemed like an unnecessary step)
I heated it to 75 and it bubbled. I mean big bubbles like 1/2 in bubbles.
I was planning on using it for higher than PLA temps, but doesn't look like it's going to work.
Directions said to preheat the bed to anywhere between 60 and 100 to smooth
it out. (Seemed like an unnecessary step)
I heated it to 75 and it bubbled. I mean big bubbles like 1/2 in bubbles.
I was planning on using it for higher than PLA temps, but doesn't look like it's going to work.