Cr10 nozzle heating to set point then reverting to
Posted: May 22nd, 2019, 7:32 pm
Hi Guys,
I’m having an issue and on 3 of my cr10 printers On the Sam power circuit. Today 3 out of 5 are heating up the nozzle to the pre determined pre heating or print heat then immediately turning to 0 before the print can initiate. Anyone come across this?
I’m having an issue and on 3 of my cr10 printers On the Sam power circuit. Today 3 out of 5 are heating up the nozzle to the pre determined pre heating or print heat then immediately turning to 0 before the print can initiate. Anyone come across this?