Cr10 nozzle heating to set point then reverting to

Discussion of ANY 3D printing topic you desire!
Post Reply
Nickq2233
Reactions:
Posts: 2
Joined: May 22nd, 2019, 7:01 pm
3D Printer(s): Cr10

Cr10 nozzle heating to set point then reverting to

Post by Nickq2233 » May 22nd, 2019, 7:32 pm

Hi Guys,

I’m having an issue and on 3 of my cr10 printers On the Sam power circuit. Today 3 out of 5 are heating up the nozzle to the pre determined pre heating or print heat then immediately turning to 0 before the print can initiate. Anyone come across this?

User avatar
LePaul
Reactions:
Posts: 3405
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): UM2+,CR-10S (x2),Tevo Tornado,FT-i3/FT-5/FT-6...
Contact:

Re: Cr10 nozzle heating to set point then reverting to

Post by LePaul » May 28th, 2019, 3:39 pm

I've never seen that
What happens if you try one printer at a time?

twoody65
Reactions:
Posts: 4
Joined: August 4th, 2019, 4:15 pm
3D Printer(s): Creality CR-10S

Re: Cr10 nozzle heating to set point then reverting to

Post by twoody65 » August 4th, 2019, 4:24 pm

I have only one printer and mine does a similar thing. It heats up and as soon as I start printing it starts cooling down. I have changed the system board to the one that the Capacitor is the new one and also replaced the Thermistor and heater element. I don't understand what the issue is any help would be appreciated.

Post Reply

Return to “General 3D Printing Conversation”