Nova Hot-end not endorsing - just requesting opinions.
Wanted to show you this Hot-End I ran across. If it works as good as Kick Starter claims maybe we should have discussion.
With 3 different power Heaters 60wt, 80wt and 100wt
An claims of 3D Printing at 300mm/sec thought I would bring it to the forums attention.
What does everyone think about the possibilities of 3D Printing at 300mm/sec.
I know this interests me even though my 3D Printer may never 3D Print at 300mm/sec.
Would be a substantial leap to double my current print Speed of 86mm/sec to 172mm/sec, though it may require some added Support Bracing.
Bring forth your opinions on the possibilities of this new Kick Starter Hot-end.
Nova Hotend
- Roberts_Clif
- Reactions:
- Posts: 1380
- Joined: March 25th, 2017, 8:17 am
- Location: Washington, State USA
- 3D Printer(s): Hictop 3DP11/12
- Roberts_Clif
- Reactions:
- Posts: 1380
- Joined: March 25th, 2017, 8:17 am
- Location: Washington, State USA
- 3D Printer(s): Hictop 3DP11/12
Re: Nova Hotend
No comments on this Nova multi wattage Heater Hotend.
- LePaul
- Reactions:
- Posts: 3970
- Joined: February 7th, 2016, 10:26 pm
- Location: Bangor, Maine USA
- 3D Printer(s): 24 - Yes I have a problem!
- Contact:
Re: Nova Hotend
I haven't looked at it...I've been drooling over the Slice Engineering Mosquito lately
- Roberts_Clif
- Reactions:
- Posts: 1380
- Joined: March 25th, 2017, 8:17 am
- Location: Washington, State USA
- 3D Printer(s): Hictop 3DP11/12