Nova Hotend

Discussion of ANY 3D printing topic you desire!
Post Reply
User avatar
Roberts_Clif
Reactions:
Posts: 792
Joined: March 25th, 2017, 8:17 am
Location: Washington
3D Printer(s): Hictop 3DP11/12

Nova Hotend

Post by Roberts_Clif » February 25th, 2019, 10:09 am

Nova Hot-end not endorsing - just requesting opinions.

Wanted to show you this Hot-End I ran across. If it works as good as Kick Starter claims maybe we should have discussion.

With 3 different power Heaters 60wt, 80wt and 100wt
An claims of 3D Printing at 300mm/sec thought I would bring it to the forums attention.

What does everyone think about the possibilities of 3D Printing at 300mm/sec.
I know this interests me even though my 3D Printer may never 3D Print at 300mm/sec.
Would be a substantial leap to double my current print Speed of 86mm/sec to 172mm/sec, though it may require some added Support Bracing.

Bring forth your opinions on the possibilities of this new Kick Starter Hot-end.
Electronics Technician / Computer Programmer

User avatar
Roberts_Clif
Reactions:
Posts: 792
Joined: March 25th, 2017, 8:17 am
Location: Washington
3D Printer(s): Hictop 3DP11/12

Re: Nova Hotend

Post by Roberts_Clif » June 11th, 2019, 9:55 am

No comments on this Nova multi wattage Heater Hotend.
Electronics Technician / Computer Programmer

User avatar
LePaul
Reactions:
Posts: 3405
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): UM2+,CR-10S (x2),Tevo Tornado,FT-i3/FT-5/FT-6...
Contact:

Re: Nova Hotend

Post by LePaul » June 11th, 2019, 10:02 am

I haven't looked at it...I've been drooling over the Slice Engineering Mosquito lately

User avatar
Roberts_Clif
Reactions:
Posts: 792
Joined: March 25th, 2017, 8:17 am
Location: Washington
3D Printer(s): Hictop 3DP11/12

Re: Nova Hotend

Post by Roberts_Clif » June 11th, 2019, 5:18 pm

LePaul wrote:
June 11th, 2019, 10:02 am
I haven't looked at it...I've been drooling over the Slice Engineering Mosquito lately
Well that also looks good with having a 50watt cartridge.
Electronics Technician / Computer Programmer

Post Reply

Return to “General 3D Printing Conversation”