Recently I redid my maker select v2 with a ramps 1.4 and ATX PSU upgrade. It's fantastic, I highly recommend it (even though it took forever). The instructional I found said to use terminal blocks to connect the wires, so I did that. I don't recommend it. Not only is it a royal pain to fit everything into the case, but the terminal blocks are finicky.
Got a notification while printing that my bed temp wasn't correct, checked the graph on octoprint and both temps had just dropped off. So I went down to check and the printer smelled like cancerous death. Took it apart and sure enough, the terminal blocks failed. Thank god octoprint/klipper/ramps/whatever was smart enough to cut off power, since it's in the basement I wouldn't have noticed until probably far too late.
Friendly reminder to make sure your wiring is done properly
Discussion of ANY 3D printing topic you desire!
Return to “General 3D Printing Conversation”
Jump to
- Announcements
- ↳ News and Announcements
- ↳ Feedback, suggestions and more
- 3D Printers
- ↳ General / RepRap Printers
- ↳ HICTOP RepRap Prusa I3
- ↳ Software and Firmware Discussion
- ↳ Hardware Modifications
- ↳ General Questions
- ↳ Original Prusa i3 MK Series printer
- ↳ Wanhao Desktop 3D Printers
- ↳ Other make/model 3D Printers!
- ↳ Large Scale 3D Printers
- ↳ Creality Large Scale 3D Printers
- ↳ Folger Tech Large Scale 3D Printers
- ↳ Tevo brand 3D Printers
- ↳ General Large Scale Printer Area
- ↳ Resin 3D Printers
- ↳ Micro 3D Printers
- Ultimaker Printers
- ↳ Ultimaker Printers Discussion
- ↳ Ultimaker S5
- ↳ Ultimaker 3 / Ultimaker 3 Extended
- ↳ Ultimaker 2 / Ultimaker 2+ / Extended & Go
- ↳ Ultimaker Original & Ultimaker Original +
- ↳ General Discussion
- Filaments, nozzles and support material
- ↳ Filament and printing material
- ↳ Special brand filaments
- ↳ PLA Filament General Discussion
- ↳ ABS Filament General Discussion
- ↳ Speciality and Experimental Filaments
- ↳ Using different nozzle sizes
- ↳ General Filament & Nozzle chat
- Getting better prints!
- ↳ Help me fix this print!
- ↳ Show off your latest print
- Software & Electronics
- ↳ Slicers and CAD Software
- ↳ Cura
- ↳ Simplify 3D
- ↳ Other Slicing programs
- ↳ CAD and 3D Modeling Software
- ↳ Slic3r
- ↳ Electronics
- ↳ General Electronics Discussion
- ↳ Firmware
- ↳ Firmware
- ↳ Wireless Printing and Controllers
- General
- ↳ General 3D Printing Conversation
- ↳ Off Topics!
- ↳ The MarketPlace
- Modders Kiosk
- ↳ General Discussion