Thingiverse is still soooo slow

Discussion of ANY 3D printing topic you desire!
Post Reply
User avatar
LePaul
Reactions:
Posts: 3966
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): 24 - Yes I have a problem!
Contact:

Thingiverse is still soooo slow

Post by LePaul »

I even tried the tip Uncle Jessy gave on the pop up blocker....still terrible slow to do anything in Thingiverse
User avatar
Roberts_Clif
Reactions:
Posts: 1372
Joined: March 25th, 2017, 8:17 am
Location: Washington, State USA
3D Printer(s): Hictop 3DP11/12

Re: Thingiverse is still soooo slow

Post by Roberts_Clif »

Not sure where Thingiverse is but I have no problems.


@GrueMaster do you have any problem with Thingiverse
Lez0
Reactions:
Posts: 400
Joined: October 8th, 2017, 10:21 am
Location: Spain
3D Printer(s): JGAurora A5S, Anycubic Photon, Saturn 2

Re: Thingiverse is still soooo slow

Post by Lez0 »

No problem here in Spain.
User avatar
Roberts_Clif
Reactions:
Posts: 1372
Joined: March 25th, 2017, 8:17 am
Location: Washington, State USA
3D Printer(s): Hictop 3DP11/12

Re: Thingiverse is still soooo slow

Post by Roberts_Clif »

Should have mentioned that I use Adblock Plus on FireFox 65.
User avatar
GrueMaster
Reactions:
Posts: 522
Joined: March 15th, 2017, 8:46 pm
Location: Oregon
3D Printer(s): Hictop 3DP-17, Hictop CR-10S

Re: Thingiverse is still soooo slow

Post by GrueMaster »

Roberts_Clif wrote: February 12th, 2019, 3:11 pm Not sure where Thingiverse is but I have no problems.

@GrueMaster do you have any problem with Thingiverse
It really depends on the time of day and the traffic to the site. I usually check it every morning while waiting for coffee (same time I check the board here). Some days it is fairly instantaneous, others it crawls so slow Firefox thinks the site has hung.

It could be the Slashdot Effect and the system is hitting max capacity from time to time.
Post Reply

Return to “General 3D Printing Conversation”