Thingiverse is still soooo slow

Discussion of ANY 3D printing topic you desire!
Post Reply
User avatar
LePaul
Reactions:
Posts: 3390
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): UM2+,CR-10S (x2),Tevo Tornado,FT-i3/FT-5/FT-6...
Contact:

Thingiverse is still soooo slow

Post by LePaul » February 12th, 2019, 11:55 am

I even tried the tip Uncle Jessy gave on the pop up blocker....still terrible slow to do anything in Thingiverse

User avatar
Roberts_Clif
Reactions:
Posts: 767
Joined: March 25th, 2017, 8:17 am
Location: Washington
3D Printer(s): Hictop 3DP11/12

Re: Thingiverse is still soooo slow

Post by Roberts_Clif » February 12th, 2019, 3:11 pm

Not sure where Thingiverse is but I have no problems.


@GrueMaster do you have any problem with Thingiverse
Electronics Technician / Computer Programmer

Lez0
Reactions:
Posts: 116
Joined: October 8th, 2017, 10:21 am
Location: Spain
3D Printer(s): FT-5, JGAurora A5S

Re: Thingiverse is still soooo slow

Post by Lez0 » February 13th, 2019, 1:48 am

No problem here in Spain.

User avatar
Roberts_Clif
Reactions:
Posts: 767
Joined: March 25th, 2017, 8:17 am
Location: Washington
3D Printer(s): Hictop 3DP11/12

Re: Thingiverse is still soooo slow

Post by Roberts_Clif » February 13th, 2019, 9:27 am

Should have mentioned that I use Adblock Plus on FireFox 65.
Electronics Technician / Computer Programmer

User avatar
GrueMaster
Reactions:
Posts: 432
Joined: March 15th, 2017, 8:46 pm
Location: Oregon
3D Printer(s): Hictop 3DP-17, Hictop CR-10S

Re: Thingiverse is still soooo slow

Post by GrueMaster » February 13th, 2019, 10:08 am

Roberts_Clif wrote:
February 12th, 2019, 3:11 pm
Not sure where Thingiverse is but I have no problems.

@GrueMaster do you have any problem with Thingiverse
It really depends on the time of day and the traffic to the site. I usually check it every morning while waiting for coffee (same time I check the board here). Some days it is fairly instantaneous, others it crawls so slow Firefox thinks the site has hung.

It could be the Slashdot Effect and the system is hitting max capacity from time to time.

Post Reply

Return to “General 3D Printing Conversation”